RS Rotary Controllers

RS1 and RS2 Rotary Controllers
Download Data Sheet
Need Something Customized?
Shop Spare Parts
Get A Quote

The RS1 and RS2 Rotary Output Selectors combine a rotary switch, on/off and direction selecting contacts, and a UFO (Ultra Feathering Operation) circuit board. They provide maintained (hands-off) output signal, including dither, to proportional, elecrohydraulic valve, or stroker. The UFO has a current controlled output and is equipped with a threshold and maximum output trim potentiometers. IRS (Intergrated Ramp System), Dual Range and a dual Maximum Output (RS2 only) options available. The electronic circuit boar is mounted directly to the rear of the rotary switch, which mounts through the panel with two mounting screws.

Features

  • Factory programmable output: proportional within 0-10V, 4-20mA, ratio metic, or absolute configuration
  • Two additional digital outputs per axis-programmable on/off position relative to handle travel
  • Short circuit and reverse polarity protection on board
  • Special Capabilities: Hall Effect/Can Bus, CAN Open,  J1939, UFO electronics (PWM output PCB with trim pot adjustments mounted to selector switch or remote mounted)
  • Mechanical Life: over 1 million cycles
  • Operating Temperature: -40°C to +70 °C
  • Degree of Protection: IP65 above panel

Mounting Dimensions

RS mounting

Information Bulletins

NOT SURE WHICH CONTROLLER IS RIGHT FOR THE JOB?

SCHEDULE A CONSULTATION
Contact Us

FROM DESIGN TO DELIVERY… TOTAL CONTROLLER SOLUTIONS

Know Exactly What You Need?

Tell Us Your Requirements

Don’t See What You’re Looking For?

Ask Us

Not Sure Where To Begin?

Start Your Search Here